CIE-A-200 EN54 Single Loop Addressable Fire Alarm System

CIE-A-200 EN54 Single Loop Addressable Fire Alarm System

Cost effective single loop panels are quickly becoming the preferred choice for small to mid-size applications where the advantages of point identification are preferred over the zonal indications provided by traditional conventional systems. Fike’s CIE-A-200 provides a reliable, cost effective solution with features normally only found in larger more expensive systems.

The CIE-A-200 Addressable Fire Alarm Control Panel is a one loop panel capable of supporting up to 200 devices* with a maximum loop length of 2KM, the panel also provides two configurable monitored input circuits, 2 configurable monitored output circuits, 2 configurable + 1 fault relay and also a Peripheral bus circuit to add up to 8 repeater panels.

The system may be configured utilising 3 alarm stages with full ‘Zone to Zone’ Cause and Effect across all 32 panel zones with provision to include alarm confirmation and delay timers. An additional 32 output zones are also provided for more complex Cause and Effect programming.

The CIE-A-200 control panel is compatible with Fike’s addressable range of devices and utilizes soft addressing principles eliminating the need for the installer to physically address each device whilst also eradicating time spent on faults caused by duplicate addressing. The operating parameters of the devices are configured either from the panel or via the OSP programming software and are then stored within the Flash memory of the device itself. This enhanced digital protocol means less information is needed to be sent between the detector and the host control panel, resulting in faster, more reliable communication.

  • Dimensions Panel (WxHxD): 353mm x 333mm x 117mm
  • Operating Temperature: +5°C to +40°C
  • IP Rating IP30
  • Main Supply Input: 230V AC Nominal
  • Standby Battery Requirement: 2 x 7Ah 12V Sealed Lead Acid (2 x 12 Ah with extended battery box)
  • Max Number of Loops: 1
  • Max Loop Length: 2000 Metres
  • Max Conductor Resistance: 24 Ohms
  • Loop Loading: 450 DLU (200 Devices Max)*
  • Loop Operating Voltage: 40V DC
  • Standby: 24V DC
  • Max Loop Current: 500mA
  • Number of Supported Zones: 32
  • LCD Display: LCD Graphical Display
  • Device Labels: 31 Characters
  • Event Log: 1000 Events
  • Repeater Panels: 8 Max
  • Aux Power Output: 30V DC 450mA
  • Inputs and Outputs: Inputs: 2 x Monitored Inputs (3k3 EOL, 680R Firing Resistor)
  • Outputs: 3 x Volt Free Relay (30V DC @ 1A Max)
  • Monitored Outputs 2 x (24V DC @ 500mA Max, 10k EOL)